had a few days off...smoker

[T.G]

Originally Posted by Gonesledn

only thing i see i dont like so far is the lid handle. it is not high enough, and your knuckles contact the lid. shouldnt betoo hard to fabricate a new handle... maybe brass. just need to figure how to make sure it stays cool, and that the lock ring will still fit.

Just some random thoughts...

You could Hit up an industrial electrical supplier, like Graybar Electric or Royal Electric and pick up a 5" Telco D-Ring.

See here 5th item down on the page. They usually just have them in bins on in front of the store.

Maybe take a section of wooden closet hanger bar, drill the center out, then split it and glue it back together over the part of the handle you would grab.

Or. pick up a pair of the big bridal rings and mount them to the lid and use a old broom handle or clothes hangar bar between them. Probably would want to use a backing plate on the inside of the lid if you go that route, as they only have one mounting hole.

Lastly, get a piece of flat steel or thick brass stock, clamp it in a vice, grab a torch and start twisting it up into something that wraps around the ends of a wooden bar or old broom handle.