My new project, I am building a smoker!

[wayner123]

Originally Posted by T.G

I'd be careful with the knotted/braided wire cups on something as thin as a drum.

Many years ago, out on one of the ships, I built a grill from a 42gal oil barrel, I used a standard straight-wire cup wheel to clean some spots where I needed to weld, and it was fine as long as I didn't bear down hard. I sneezed at one point and jammed the angle grinder into the barrel and it tore up the surface. Had I been using a knotted/braided cup, it probably would have gouged right through the barrel.

Hmmm.... the weed burner and my drill mounted wire wheel is sounding better. I may try the flexible sanding disc as well.

[kgoings]

Originally Posted by wayner123

Hmmm.... the weed burner and my drill mounted wire wheel is sounding better. I may try the flexible sanding disc as well.

I tried the weed burner....too slow for me, the flexible sanding disk with like 60 grit should clear it off quick...I used it by hand it was pretty quick.

[wayner123]

Originally Posted by kgoings

I tried the weed burner....too slow for me, the flexible sanding disk with like 60 grit should clear it off quick...I used it by hand it was pretty quick.

Got a pic or link to the one you used? I thought you meant one of those flexible sanding disc pads that goes on your angle grinder.

[kgoings]

Originally Posted by wayner123

Got a pic or link to the one you used? I thought you meant one of those flexible sanding disc pads that goes on your angle grinder.

This is what I meant....and in my post when I said I used it by hand...I meant th 60grit sandpaper sorry for the confusion.