And Dell managed to get on my nerves today...

[JE3146]

Originally Posted by Volt

Whoops, yep I got distracted with the caps and my past experience with the GX260s/GX270's, completely missed the level workstation. Did a run on a cheap Precision T3500 64bit with a small RAID 5, $1,700.

Depending on the age of the machine, the reliability required and when it needs to be back up, it may be new server is required. If the piggy says no $$$, maybe buy the kit and and install it. I would wager a years' worth of cigars though, unless it's done by someone who has 2M skills and a 2M workstation, it will be an expensive failure. Those caps are a tight fit and power caps have to be done right.

All these capacitors have leads. They're not SMT. Just seat them flush and even to the PCB.

I've done cap swaps on motherboards and PSU's with no ill-effects whatsoever.

As long as a person cleans the through-holes cleanly with a solder sucker or wick(just be careful not to stray to other components), properly applies some flux to not burn out the components, double checks for no cold joints, and uses a soldering iron proper for the job. IE nothing over 50W with a fine tip. This should be easy as cake.

[Volt]

Originally Posted by JE3146

All these capacitors have leads. They're not SMT. Just seat them flush and even to the PCB.

I've done cap swaps on motherboards and PSU's with no ill-effects whatsoever.

As long as a person cleans the through-holes cleanly with a solder sucker or wick(just be careful not to stray to other components), properly applies some flux to not burn out the components, double checks for no cold joints, and uses a soldering iron proper for the job. IE nothing over 50W with a fine tip. This should be easy as cake.

Hehe - a 5 line sentance with a lot of IFs. I agree, not overly diificult, but I would still say not for the average person who has never done proper soldering. 50 caps = 100 joints with proper tinning, no cold joints, no slop, burning up the run, or getting the polarity backwards. Not to include gettin the right cap in the right spot..... I'm still betting a years worth of sticks against an untrained individual getting it right the first time if at all.

1 years worth of cigars = all the Creamosas you can smoke.

[JE3146]

Originally Posted by Volt

Hehe - a 5 line sentance with a lot of IFs. I agree, not overly diificult, but I would still say not for the average person who has never done proper soldering. 50 caps = 100 joints with proper tinning, no cold joints, no slop, burning up the run, or getting the polarity backwards. Not to include gettin the right cap in the right spot..... I'm still betting a years worth of sticks against an untrained individual getting it right the first time if at all.

1 years worth of cigars = all the Creamosas you can smoke.

You changed your bet

And I will agree that an untrained individual might not be able to do it. But technically I'm untrained aside from an intro class in college that pretty much just said don't burn your @&^# fingers .

I've just had a LOT of experience since then though. To me it's easy. The other day I had to solder a 64 pin TQFP microcontroller to a PCB. That's about what I'd consider moderate difficulty