Project Of The Day : Desktop Thermoelectric Winadors

[shilala]

Originally Posted by Jefft72

Looks like a lot of fun! I'll be looking for more progress pics as you get the final units finished.

Here's an idea for your drawer jig: Use some scrap stock that would be fixed to the work surface that will hold the drawer sides upright and square to the others. You could use some 2x2 on either side of the drawer side so that the drawer pieces are held in place. Apply glue to the ends and then set the drawer bottom on top with some glue and a few brads (drawer assembled upside down). 4 clamps to hold everything tight.

Given your available work area you could have several of these setup in glue.

That'd work, but my side stock is under 3/8" and it's all presanded. If I smear glue all around the inside of the box, it'll cost me more time than I saved.
I managed to work out a clamping setup that allows me to clean the glue, pre-drill and nail everything, and keep everything square. I just gotta move fast.