My first humidor

[mojo65]

Originally Posted by Kreth

So I'm salt testing my Hygroset. I figure I can get that dialed in and use that to calibrate the analog that came with my humidor. After 12 hours this morning it was sitting at 64%. I'll let it go another 12 and see where it ends up.
I put a dish of distilled water and a Puck in my humidor, with about 60-70% of the beads translucent. When I checked this morning it looked like most of the beads were translucent. Should I take the Puck out until I get my humi at the target RH?

Ceder will absorb a large amount of water. Get a brand new sponge, and wipe the interior with distilled water. leave the wet sponge in the Humi on a foil sheet. you may need to repeat this several times to fully season the humi.

Recharge the puck too.

As too the salt test dont get in a hurry.....

[Kreth]

Originally Posted by mojo65

Ceder will absorb a large amount of water. Get a brand new sponge, and wipe the interior with distilled water. leave the wet sponge in the Humi on a foil sheet. you may need to repeat this several times to fully season the humi.

I read few seasoning FAQS that said to do this, and then others that said not to as it can raise the grain of the wood. Those recommended just using a dish filled with distilled water.

Recharge the puck too.

As of this morning, the beads were pretty much all translucent, which I understood meant that they were holding water. I need to charge them when they turn chalky, right?

As too the salt test dont get in a hurry.....

Is 24 hrs enough, or should I go even longer? I've seen everything from 6 hrs to 24.

[68TriShield]

Leave the beads alone,they're still wet.
And don't stress too much.Cigars are for enjoyment