a journey into pipe making......

OnePyroTec · 01-14-2014, 02:53 AM

Ended up starting a similar shape today. I can't believe I forgot to take the "BEFORE" picture. I put a couple chunks of the briar back in place after rough shaping just to show the original type of block I started with. I cheated and used a band saw to cut off the two larger sections to save time. Rough shaping was done with a 60 grit disc on a shaper...then 80 by hand, & just started 120 when I called it a day...the pictures are from just after starting 80 grit.

01-14-2014, 02:53 AM	#11
OnePyroTec Adjusting to the Life Join Date: Jan 2013 First Name: Wayne Location: Nevada Posts: 332 Trading: (2)	Re: a journey into pipe making...... Ended up starting a similar shape today. I can't believe I forgot to take the "BEFORE" picture. I put a couple chunks of the briar back in place after rough shaping just to show the original type of block I started with. I cheated and used a band saw to cut off the two larger sections to save time. Rough shaping was done with a 60 grit disc on a shaper...then 80 by hand, & just started 120 when I called it a day...the pictures are from just after starting 80 grit.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode