Where are the crafty Inmates

[Mark C]

Originally Posted by livwire68

2. What is the best way to glue the bands to the wood (Product names)? Also how long to cure prior to sealing. Here Again I would use the spray adhesive in small sections at a time, can be tedious work putting bands on. Also cover any bands while you spray, you dont want any on finished bands

3. What is the best way to seal it after, I am assuming polyurethane but is there something better? They make a coating they use for bar tops, cant remember what it is called. Dries hard and clear, caution if wet will be a slick surface!

These were the two suggestions I was going to post! Especially the spray adhesive, I think anything else would be far too tedious for a whole floor.