V-cut cutter?

[neoflex]

I actually prefer a V-Cut except on Torps and Belis. I feel I get a cleaner cut than a Guillitine and I just don't like a Punch for some reason.

Originally Posted by neoflex

I actually prefer a V-Cut except on Torps and Belis. I feel I get a cleaner cut than a Guillitine and I just don't like a Punch for some reason.

What brand V cutter do you use or have used? Any reccomendations?

The reason I like my Punches is that they make a nice cut without tearing. The ones I make stay sharp and don't break or loosen. I hate the punch that comes on the torch type lighters as they seem to come loose and are not big enough and are not very sharp. On my sheels I drill out the primer pockets to almost the diameter of the inside of the case. This gives a place for the debris to go but it doesn't just fall out leaving little cut discs in your pocket or on the floor. Then every so often you just clean it out.

[neoflex]

Originally Posted by mscales

What brand V cutter do you use or have used? Any reccomendations?

I actually use the cheap $5 one I got from my local B&M although a Xikar is on the short list. When I am home I have a stainless table top one that has two different sized holes for the caps. I can get the brand for you when I go back out to the garage.