Where are the crafty Inmates

[groogs]

Originally Posted by SilverFox

As I have mentioned elsewhere I am putting together a walk in humi.

I was given an idea from a fellow inmate (Mikey I think) to laminate bands to make my floor I love the idea.

I have a few questions for the crafty Inmates.

1. I am just going to use one side finished 3/4 inch plywood for the floor and laminate the bands to it. I am putting it down on concrete do I need any padding rubber backing underneath it?

2. What is the best way to glue the bands to the wood (Product names)? Also how long to cure prior to sealing.

3. What is the best way to seal it after, I am assuming polyurethane but is there something better?

3. The bands are mostly still circles what is the best way to seperate them without having them peel?

4. Should I flatten the bands before gluing them so they stick down?

As usual all thoughts and ideas are appreciated.

5.

1. would at least put down a plastic barrier underneath to stop any moisture that might come from the concrete.

2. I would just use some super glur ethat dries clesr, so it doesn't hurt the bands.

3. I would use a two part epoxy to seal the bands. I can't remember the name, but there are two part epoxies that you mix together and then pour onto the surface to be covered. That will provide a thick durable covering. It may get scratched over time, but it can always be sanded and re-finished without hurting the bands.

3. I don't know the best way to separate the bands. I think it really depends on the type of paper and the type of glue used in how clean they come apart.

4. I think flattening the bands would make glueing them easier, but I don't think it is necessary.



I am sure there are craftier BOTL's than me, but those are some of my ideas.