If you could build the perfect draw tool

10-07-2009, 12:35 PM

How big of a diameter would you like to see

I am thinking 1/16th I have some draw tools that have a tendency to cause splits in smaller RG sticks. Perhaps you want two sizes. A 1/16th and a 3/32nd?

Would you like it to be a drill bit? So you could drill it in and maybe draw a bit of tobacco out?

How about handle? T Style...........L Style or just a round handle.

Your thoughts would be appreciated

10-07-2009, 12:35 PM	#1
SilverFox Guest Posts: n/a	If you could build the perfect draw tool How big of a diameter would you like to see I am thinking 1/16th I have some draw tools that have a tendency to cause splits in smaller RG sticks. Perhaps you want two sizes. A 1/16th and a 3/32nd? Would you like it to be a drill bit? So you could drill it in and maybe draw a bit of tobacco out? How about handle? T Style...........L Style or just a round handle. Your thoughts would be appreciated

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode