|
08-31-2009, 09:12 PM | #24 | |
God Like Status
|
Re: Electrician question?
Quote:
My entire work is in residential. Here are the common finds. 1. The ground wire may be attached to the back of the box on the clamp/screw. 2. It may be twisted around the wire before it was inserted into the box. 3. It may be cut short in the sleeve. 4. If you have BX cable it may be pulled back and wrapped around the cable before it was inserted. I honestly can't remember the last time I found a home without a ground wire - and I work in a lot of old homes (my home is 1956). Also - go pull off the circuit/fuse box cover and look. See if you have a black/white/copper there. If so - then they are at the box somewhere. Someone mentioned having the home rewired. Don't toss out this idea. Keep in mind that the electrical needs of a family in the 50's verse now is huge. They had what - a few radios, one TV and maybe a blender and toaster in the kitchen. Compare that to what you have. During my remodel last year I upgraded my box from the old 60 amp to 200 with a power up. In addition I had them pull damn near every inch of old wiring and replace it all - bringing the house and the new kitchen up to current code. Now we can run the microwave, toaster and the bathroom hair dryer with out blowing a circuit - I could have done it myself - but it was a lot faster hiring an electrician. Plus I went from a 60 amp panel with 22 breakers to a 200 amp with 42 breakers - plus - another sub panel with another 22 breakers - and a 17Kw generator. Yes it was pricey but worth every penny. Anyway - good luck with it all. Ron |
|
Thread Tools | |
Display Modes | |
|
|