|
01-13-2016, 02:43 PM | #161 |
Bunion
|
Re: Sous vide
Going to do a rib eye today. Plan to use a very good (commercial) rub which I will remove before the sear. I plan to sear in cast iron with a minimal amount of oil to keep the mess as small as I can.
__________________
I refuse to belong to any organization that would have me as a member. ~ Groucho Marx |
01-13-2016, 02:43 PM | #162 |
Grrrrrr
|
Re: Sous vide
The Searzall is available on Amazon again for $75, and the TS8000 torch is down to about $40 right now.
http://www.amazon.com/Searzall-Torch...words=searzall |
01-13-2016, 02:46 PM | #163 | |
Bunion
|
Re: Sous vide
Quote:
__________________
I refuse to belong to any organization that would have me as a member. ~ Groucho Marx |
|
01-13-2016, 02:59 PM | #164 |
Don't knock the Ash...
|
Re: Sous vide
Why remove the rub?...not sure you'll get much "penetration" into the meat flavor wise with a pre-bath rub...curious as to your thoughts?
__________________
Keith |
01-13-2016, 03:33 PM | #166 |
Don't knock the Ash...
|
Re: Sous vide
Yea, figured that...maybe a post-sear sprinkle for flavor...
__________________
Keith |
01-16-2016, 12:24 PM | #170 |
Grrrrrr
|
Re: Sous vide
Since everyone else is doing it, I decided to try some SV roast beef too. My experience in the past with 30-ish hour cooks on other meats seems to show the same issues as what Keith and Dom described, and that is the meat takes on a mushy texture, so this time I went for 18 hours at 130F on another one of the tougher cuts of meat, this one being a small (~2 lb) sirloin tip roast. Seared on cast iron and with a searzall. Still want to tweak things a bit, but came out pretty good overall. The cut meat in the 3rd photo is the larger muscle of the group, the one on the left in the top photo and the upper chunk in the middle photo, I thought I was cutting against the grain, but for some reason it came out odd looking, like it was either twisted up or somehow I got it slightly off when loading it on the slicer.
|
01-17-2016, 09:46 AM | #172 | |
Grrrrrr
|
Re: Sous vide
Quote:
The smaller of the two muscles (the lower one), which I chilled before slicing, came out texture wise more like deli roast beef, but lacked flavor. There was also a tiny third muscle cut there, you can kind of see it poking out at the bottom of the searing photo, about the size of a carrot. That one came out more like a grilled steak. I think it would have sucked cold. I think I need to do better job trimming next time, I thought it looked ok going in, but after it came out of the bath, wasn't really happy with how much I left. I'm going to try this again, but use a specific single muscle and see what I get. While the sirloin tip roast wasn't bad, I think it would have been better suited to being tossed in the pellet grill and treated like pork butt and given an overnight cook and then some at 200 +/- or into either a dutch oven or pressure cooker and turned into ropa vieja. Last edited by T.G; 01-17-2016 at 09:52 AM. |
|
01-17-2016, 06:11 PM | #174 |
Where's my buffaloooo ...
|
Re: Sous vide
Tenderloin Fillets tonite ...
Was gifted an assortment of Wagyu steaks from Snake River Farms in Idaho. Set the water bath for 137.5*, let them do their thing for about an hour, and finished them off with a little salt & pepper rub and a butter-sear on the skillet. Tremendous flavor, incredibly tender. Sooooooooo good! |
01-18-2016, 08:52 AM | #176 |
Where's my buffaloooo ...
|
Re: Sous vide
These were gifted so difficult to assess actual value, but I eat at nicer steak houses in Boston often enough to say these compare favorably with the quality of steaks at places like Capitol Grille, Morton's, Abe & Louie's etc. However, the portion size was small - very much a petite fillet.
On the plus side, the steaks come already vacuum sealed - perfect for the Anova. The Wagyu beef is different from "normal" beef, and I had not experienced it before. The Wagyu is extremely tender -- literally cut it with a fork tender. Lots of fat in the Wagyu steak but in a good way -- not huge chunks of fat, but more distributed throughout the beef. Super flavorful. I did the sear with just a touch of salt & pepper because I wanted the full on flavor of the beef, and it didn't disappoint. This rocked as a gift (and there are more in my freezer ) but I'd need to research price to know if I'd buy directly. My sense is it is likely to be cost prohibitive for the size steaks I'd like, particularly since you have to factor in shipping. Glad to have had the opportunity to try these and look forward to cooking up the other cuts in my freezer. |
01-18-2016, 09:14 AM | #177 | |
Where's my buffaloooo ...
|
Re: Sous vide
Quote:
|
|
01-18-2016, 11:00 AM | #178 |
Don't knock the Ash...
|
Re: Sous vide
started with 3 ribeyes...applied a commercial rub (Costa Carne, excellent on beef!)...vac sealed and into bath at 130 for an hour...pan seared (not cast iron this time, got lazy and used same pan I sauteed green beans and mushrooms)...decent sear...tasty......
__________________
Keith |
01-18-2016, 01:36 PM | #179 |
F*ck Cancer!
|
Re: Sous vide
Looks great, Keith!
__________________
Need Beads? Need Five Finger Bags? 2 of 3 Requirements for use of the CA Rolodex: 100 posts/ 60 day membership/ participation in trade (trader rating). New members can be added at any time. |
01-18-2016, 08:47 PM | #180 |
F*ck Cancer!
|
Re: Sous vide
Inspired by Adam's results, we picked up a 2.5 lb USDA Prime tri-tip from Costco. I marinaded the tri-tip for two hours before cooking and included the marinade in the vacuum bag.
The marinade is pureed onion, garlic, extra light EVOO, red pepper flakes, salt, and pepper. I cooked it for 8 hours @ 130* and then seared it for 60 seconds on each side in Duck fat. I think this is the best tri-tip I have ever made (I usually grill them). The meat was tender, had a great texture and mouth-feel and was very juicy.
__________________
Need Beads? Need Five Finger Bags? 2 of 3 Requirements for use of the CA Rolodex: 100 posts/ 60 day membership/ participation in trade (trader rating). New members can be added at any time. |
Thread Tools | |
Display Modes | |
|
|