Quote:
Originally Posted by germantown rob
Not my skin, I don't think it was, but the skin milk gets when burned.
I have the whole aloe vera plant in my kitchen. I have a knack for burning myself so I cut some off and tape it on the burn(s) as needed.
Thanks for the info on the dispersion screen.  Is not taking the screw out hot for me or is it bad for the threads?
I tried some water out of the group head after a bunch of shots where pulled and the machine had sat for a while, very nasty stuff and brown. I like to backflush after shots if I know I won't be having another for a while, it is amazing what flows out each time. How often do you backflush with detergent? |
Heat and accumulated grunge will cause the dispersion screen screw to get very snug; it's easy (well, easier) to remove when cold and, if hot, it's no trick to strip the screw slot (which you totally don't want to do). Be sure to use a properly sized screwdriver that fills the slot without sloppiness or you will strip the slot; way better to replace with a phillips, torx or allen machine screw BEFORE the catastrophe.
Backflush: start with a hot machine. Add a teaspoon or so of CleanCaf, Urnex (whatever floats your boat) and some hot water to the PF with a blank basket and stir it up for a few seconds as if to dissolve some of it. Keeping the basket rim clean and level, seat it firmly in the grouphead. Take out the drip pan grate and then hit the brew button "ON" until the pump goes quiet then "OFF". Repeat the process a few times until you're satisfied the Urnex and water have worked all the way thru the solenoid and are draining into the drip pan. Let it sit for a few hours then do the ON/OFF thing a few more times until it drains clean. Remove the pf from the grouphead, wash it off and repeat without the Urnex until nothing but clean water is showing in the drip pan as you cycle the brew pump "ON" and "OFF".
Oscar note: if you run brew water and do the "portafilter wiggle" back and forth from loose to snug (to rinse grounds off) you may end up seizing the pf into the grouphead. Doing the wiggle can force water under the grouphead gasket, and, later, make it very had to free up a snugged pf without a lot of muscle. Run brew water over a pf to clean it or heat it up but don't lock- or gently snug it into the grouphead while the pump is on.