View Single Post
Old 01-21-2009, 11:29 AM   #1
mojo65
Relocation Engineer
 
mojo65's Avatar
 
Join Date: Oct 2008
First Name: mark
Location: Evans,CO
Posts: 240
Trading: (4)
Punch
mojo65 is on a distinguished road
Default Re: My first humidor

Quote:
Originally Posted by Kreth View Post
So I'm salt testing my Hygroset. I figure I can get that dialed in and use that to calibrate the analog that came with my humidor. After 12 hours this morning it was sitting at 64%. I'll let it go another 12 and see where it ends up.
I put a dish of distilled water and a Puck in my humidor, with about 60-70% of the beads translucent. When I checked this morning it looked like most of the beads were translucent. Should I take the Puck out until I get my humi at the target RH?
Ceder will absorb a large amount of water. Get a brand new sponge, and wipe the interior with distilled water. leave the wet sponge in the Humi on a foil sheet. you may need to repeat this several times to fully season the humi.

Recharge the puck too.

As too the salt test dont get in a hurry.....
__________________
Mark,
I'LL TAKE MY GUNS, RELIGION & MONEY... YOU CAN KEEP THE CHANGE!
mojo65 is offline   Reply With Quote