I finished up the parts list. Next I'll print it and try to lay out my board footage. That's gonna be tough. There's a LOT of lumber in these two desks. Heck, there's a lot of lumber just in the desktops.
Once I get that list together I'll go fetch my trailer and head to the mill. Maybe tomorrow.
Thing is that it's up to about 45* here now and the roads are going to be a sloppy mess. I'll have to wrap this lumber or let it get all muddy, not that that matters. It'll just dull my planer blades, that's why it's best to keep it clean.
Anyways, here's a parts list just to give you an idea of how easy it looks. It takes a lot of brain time to get from concept to parts list. Now I can just go back to being a dimbo and watch Family Guy and sports radio all day while I work.
Oh, I wanted to mention what the "g" means in the measurements. It's just a note for me so that when I make the piece I get the grain correct. The grain is intended to span that specific dimension.
Ya can't have grain running left and right where it's supposed to go up and down, it looks awful. That'd be a lot of wasted work and the piece would get cut up for smaller parts. I try to avoid that, but I screw up every now and then. It's hard to think of all that stuff all the time while you're working.
Large Panels
8 - 26g x 25.5 x .75
sides and centers for 2 desks, 4 get panelized
2 - 26g x 28 x .75
center Fronts for 2 desks, get panelized
4 - 26g x 18 x .75
left and right front, 2 desks, all get panelized
2 - 68g x 26.5 x 1.0
desktops, get routered reveal, top ground for bartop
4 - 26.5g x 20.5 x .75
pedestals for 2 desks, get routered reveal
2 - 28g x 24 x .75
center drawer frame bottom, 2 desks
Small Parts
8 - 19.5g x 2.25 x .75
base fronts and backs, 2 desks, get 45'd, make long
8 - 25.5g x 2.25 x .75
base fronts and backs, 2 desks, get 45'd, make long
4 - 28g x 3 x .75
center drawer fill, top and bottom, 2 desks
4 - 3.5g x 3 x .75
center drawer fill, left and right, 2 desks
Face Frame Parts
8 - 26g x 1.5 x .75
left and right risers, 6 receive mortises
14 - 15g x 1.5 x .75
all receive tenons, make 2" long
Drawer Fronts
6 - 17g x 5.625 .75
3 - 17g x 11.75 x .75
1 - 24g x 17 x .75 (door front, my desk)
2 - 27g x 4 x .75
Drawer Glides and hardware
11 - pairs Knapt & Vogt 24" glides (3 sets over 100 pounds)
22 - Anachrome front brackets
22 - Anachrome rear brackets
1 - pair socket hinges (or create wood hinges)
56 - 1" screws (center drawer fill)