Cigar Asylum Cigar Forum - My Basement Lounge Project is Officially Underway

Cigar Asylum Cigar Forum (http://www.cigarasylum.com/vb/index.php)

- All Cigar Discussion (http://www.cigarasylum.com/vb/forumdisplay.php?f=5)

- - My Basement Lounge Project is Officially Underway (http://www.cigarasylum.com/vb/showthread.php?t=19869)

My Basement Lounge Project is Officially Underway

After some saving and selling.. I've finally been able to begin my new Project. A fully ventilated, closed off room in the basement. My lounge.

Free from the 101˚ / 90% humidity days of the Virginia Summer and the 5˚ (-5 windchill) winter days that come with it.

The ability to smoke a cigar while I decide to either watch my Sox fight for another World Series or Clint Eastwood tell someone off.

The day has finally come and today I have started my project. Below are some initial pictures of the room. I've determined how much lumber I need as well as drywall. I've located the vent and additional duct accessories. I've also picked out the flooring. With luck, my room will be complete before the middle of September, time allowing.
**********************************

Picture 1: This is the actual area for the lounge. You can see the chalk line that runs along the bottom of the room. The total dimensions (after finishing) will be 12' 4" x 12' 6" (the nook on the left side of the picture is not included in the dimensions as I will explain later).

http://www.1337designs.com/images/ci...nge/Lounge.jpg

Picture 2: This "nook" is 11' x 16". This will used for two things. A 1' panel will be added to the left side of the nook as this is where the air intake from the outside will be located. This will also house the inline duct heater which will help in keeping the room approximately 70˚ when in use. The remaining 10' to the right will be a built in Cabinet Humidor. Shelves along the top with 30" storage cabinets along the bottom.
http://www.1337designs.com/images/ci...ge/Lounge2.jpg

Picture 3: This is the view from the far corner (the right side of the picture above). One of the first things I will need to do is to move the vents from the well to the left of the door to the adjacent wall on the other corner. The builder informed me those are only there to provide more air to the utility closet so moving those will not harm anything. The door will be replaced with a french door and will be sealed with heavy duty weather stripping and a heavy duty sweeper.

The wall is noted with a white line. Part of the project is to build a 9' x 12' 4" Exercise room for my wife. She will have a matching French door which will involve relocated the two studs to the right of my door.

For both rooms I will need to build a bulkhead around the HVAC duct that is running crossways from the floor joists above. I will be tapping into this duct for my HVAC for when the room is not in use. The outside intake and inside HVAC will be switched using Electronic Dampers (HVAC Open when not in use, Outside Closed).

http://www.1337designs.com/images/ci...ge/Lounge3.jpg

Picture 4: Square Baby!

http://www.1337designs.com/images/ci...ge/Lounge4.jpg

Some things I am doing to prevent smoke from escaping out of the room is not putting in can lights. All lights will be wall mountable sconces. We also plan on putting R13 Insulation around the room just to help filter anything additional.